چکیده مقاله
The purpose of this article is to propose and simulate a simple and applied method without complex and time consuming calculations to control the voltage and reactive power in distribution network in presence of DG using Fuzzy logic Moreover, the DG active and reactive power calculation equations proportional to the electric power distribution network includes airlines conductors and will be calculated so that do not lead to the voltage increase in at the point of connection to network Therefore, in order to prove the equations and correctness of the proposed method simulations were implemented based on, ۳۴ NODE TEST FEEDER IEEE network in ETAP software, and the effects of capacitive structure compensation and DG installed were analyzed in different upload situations in three different scenarios and the best utilization scenario was achieved
کلیدواژهها
نویسندگان
محمود صدوقی
۱Department of Electrical Engineering, Islamic Azad University, Ferdows, Iran
Mehrdad Meshkat
Department of Electrical Engineering, Islamic Azad University, Gonabad, Iran
Javad Sayar
Department of Electrical Engineering, Islamic Azad University, Ferdows, Iran
Hamed Shafayani
۱Department of Electrical Engineering, Islamic Azad University, Ferdows, Iran
Mehdi Elahi
۱Department of Electrical Engineering, Islamic Azad University, Ferdows, Iran
Amin Karamad
۱Department of Electrical Engineering, Islamic Azad University, Ferdows, Iran
شیوه ارجاع
Sadoughi، Mahmood و Meshkat، Mehrdad و Sayar، Javad و Shafayani، Hamed و Elahi، Mehdi و Karamad، Amin،1400،Voltage and reactive power control in distribution networks in the presence of distributed generation sources using fuzzy logic،هشتمین کنگره ملی تازه های مهندسی برق و کامپیوتر ایران،تهران
ارائهشده در
مجموعه مقالات نهمین کنگره ملی تازه های مهندسی برق و کامپیوتر ایران29 آبان 1401 · تهران