چکیده مقاله
Traditionally, workpiece holding fixtures have been designed and fabricated only for mass production whereby high lead time and high cost of fixture design and preparation is justified through huge amount of parts which have been produced New tendency toward manufacturing of low volume, high repetitive products compels manufacturing engineers to modify conventional opinion of fixture design for lowvolume production in order to minimize and if possible eliminate design and preparation of fixtures A new technology of machining plate like components is represented in this paper and its possibility is validated through a practical test
کلیدواژهها
نویسندگان
M Rahi
M S Student of Mazandaran University
Muhammad Shakeri
Associate Prof University of Mazandaran, Faculty of MechanicalEngineering,
M Bakhshi
Associate Prof
شیوه ارجاع
Rahi, M and Shakeri, Muhammad and Bakhshi, M,1384,Development of Setup-free Machining Technology of Plate-like Components (Software & Hardware),01st Tehran International Congress on Manufacturing Engineering (TICME2005),Tehran
ارائهشده در
مجموعه مقالات اولین کنفرانس بین المللی و هفتمین کنفرانس ملی مهندسی ساخت و تولید1 فروردین 1384 · تهران