چکیده مقاله
Tube hydroforming technology is still considered as a new technique growing fast in automotive and aircraft industries It requires many researches and developments on all aspects of this process Internal pressure and axial feeding are the most effective parameters on success of the process without any common defects In this paper, an experimental setup for tube hydroforming is designed after calculation of all the main parameters affecting the process The hydraulic control system is designed for two forms of linear and nonlinear pressure application Defined pressure and feeding loading paths are applied and experimentally tested
کلیدواژهها
نویسندگان
S.M.H Seyedkashi
PHD student, Mechanical Engineering Department, Tarbiat Modarres univ
Gh Liaghat
Professor, Mechanical Engineering Department, Tarbiat Modarres univ
H Moslemi Naeini
Associate Professor, Mechanical Engineering Department, Tarbiat Modarres univ
شیوه ارجاع
Seyedkashi, S.M.H and Liaghat, Gh and Moslemi Naeini, H,1386,Design and Manufacturing of a Tube Hydroforming System,02nd Tehran International Congress on Manufacturing Engineering (TICME2007),Tehran
ارائهشده در
مجموعه مقالات دومین کنفرانس بین المللی و هشتمین کنفرانس ملی مهندسی ساخت و تولید10 اسفند 1386 · تهران