چکیده مقاله
In this work, an experimental study in cylindrical wire EDM machining parameters followed by artificial neural network is presented Experiments have been done by means of the technique of design of experiments DOE with the three levels fractional factorial method An Artificial neural network ANN has been used for predicting machining parameters, using the experimental parameters as input and results as target It is shown that DOE combined with ANN can be very useful in experimental applications, especially in the field of manufacturing which input parameters are too many to design full factorial experiments The superiority of this approach is highly noticeable when there is only experimental data which demonstrate the process behavior, and little or no explicit mathematical relationships, based on the physics of the process, are available to correlate the input and output parameters
کلیدواژهها
نویسندگان
H Mohammadi
MSc Student of Mechanical Engineering, Manufacturing, IUT
K Torkzadeh
MSc Student of Mechanical Engineering, Manufacturing, IUT
A.R Fadai Teharani
Assistant Prof in Mechanical Engineering Faculty, Isfahan University of Technology
شیوه ارجاع
Mohammadi, H and Torkzadeh, K and Fadai Teharani, A.R,1387,Evaluation of Surface Roughness and Material Removal Rate in CWEDM Using DOE and ANN,9th Iranian Conference on Manufacturing Engineering,Birjand
ارائهشده در
مجموعه مقالات نهمین کنفرانس مهندسی ساخت و تولید13 اسفند 1387 · بیرجند