چکیده مقاله
An IF steel was subjected to friction stir processing using a carbidetungsten pin with the diameter of 16 mm The rotating speed of pin was 1600rpm, whereas, the applied traverse speed was 31 5mm/min The specimens were water quenched immediately after the FSP The results show that the FSP of IF steel resulted in the formation of a 30 35 μm thick surface layer with the nanograins of 50 125 nm There was a continuous decrease in the hardness from the nanograin surface layer towards the center of specimen There was almost a three fold increase in the hardness
کلیدواژهها
نویسندگان
A. Chabok
Ms Student, Faculty of Mining and Metallurgical Engineering, Amirkabir university of technology
K. Dehghani
Associate Professor, Faculty of Mining and Metallurgical Engineering, Amirkabir university of technology
M. Mazinani
Ms Student, Faculty of Mining and Metallurgical Engineering, Amirkabir university of technology
شیوه ارجاع
Chabok, A. and Dehghani, K. and Mazinani, M.,1389,Formation of nanograin in IF steels by friction stir processing,11th Iranian Conference on Manufacturing Engineering (ICME 2010),Tabriz
ارائهشده در
مجموعه مقالات یازدهمین کنفرانس ملی مهندسی ساخت و تولید ایران27 مهر 1389 · تبریز