چکیده مقاله
The laser forming process is an advanced process in sheet metal forming in which laser heat source is used to shape the metal sheet In this paper, temperature distribution in sheet metals is investigated numerically and experimentally Laser heat source is applied through curve paths in square sheet metal parts Finite element simulation is performed with ABAQUS/CAE standard software package Material property of AISI 1010 is used in FE model and experiments The aim of this study is to identify the response related to deformation and characterize the effects of process parameters respect to the bending angle for a square sheet part An experimental setup including a Nd:YAG laser, Model IQL 10, with maximum mean laser power of 500 W is used for the experiments to verify FEA results It is observed that numerical results relatively are in agreement with the experimental results Result show that the increasing laser power influenced the deformed shape
کلیدواژهها
نویسندگان
M. Hoseinpour Gollo
Asistant Professor, Dept of Mechanical Eng , Faculty of Engineering, Mohaghegh Ardabili
S.M. Mahdavian
senior lecturer, School of Aerospace, Mechanical & Manufacturing, RMIT University, Bundoora
H. moslemi naeini
Professor, Department of Mechanical Engineering, Tarbiat Modares University, Tehran
شیوه ارجاع
Hoseinpour Gollo, M. and Mahdavian, S.M. and moslemi naeini, H.,1389,Numerical And Experimental Investigation Of Deformation In Laser Forming Process,11th Iranian Conference on Manufacturing Engineering (ICME 2010),Tabriz
ارائهشده در
مجموعه مقالات یازدهمین کنفرانس ملی مهندسی ساخت و تولید ایران27 مهر 1389 · تبریز