چکیده مقاله
Cold tube drawing has found extensive application in variousindustries This study explores the feasibility on theprediction of hole geometry after cold drawing based on itsinitial geometry during the tube drawing process To this end,the variation trend of the hole diameter was determined in thefirst series of the tests In the second series, initial holes withspecific geometries were converted into circular holes withpredefined diameters Studies indicated that the developedprocedure could create circular holes with a 6 to 12 mmdiameter at acceptable accuracy for the tube diameter of 33mm
کلیدواژهها
نویسندگان
Navid. Parsaei
MSc, Mechanical Engineering Department, Najafabad Branch, Islamic Azad University, Najafabad, Iran
Masoud. Farahnakian
Assistant Prof , Mechanical Engineering Department, Najafabad Branch, Islamic Azad University, Najafabad, Iran
Arsalan. Torabi
PhD, Mechanical Engineering Department, Amirkabir University of Technology, Tehran, Iran
Sadegh. Elhami
Assistant Prof , Mechanical Engineering Department, Faculty of Engineering, Ferdowsi University of Mashhad, Mashhad,Iran
شیوه ارجاع
Parsaei, Navid. and Farahnakian, Masoud. and Torabi, Arsalan. and Elhami, Sadegh.,1401,Feasibility study on the prediction of hole geometry on the thin wall tube during tubedrawing process,The 19th National Conference and the 8th International Conference on Construction and Production Engineering of Iran,Mashhad
ارائهشده در
مجموعه مقالات نوزدهمین همایش ملی و هشتمین کنفرانس بین المللی مهندسی ساخت و تولید ایران18 اسفند 1401 · مشهد