چکیده مقاله
Additive manufacturing technology is one of the new methods of manufacturing parts in various industries One of the applications of additive manufacturing is the manufacture of bio scaffolds The aim of the present study is to compare the mechanical properties of scaffolds with different geometries that have similar dimensions and different porosity In this study, two scaffolds with linear geometries and placement angles of 0 90 and 0 45 degrees and one square scaffold were designed and printed Then, for the scaffold with the highest compressive strength, finite element simulation was performed using ABAQUS software By performing pressure tests on the printed samples, it was determined that the scaffold with square geometry has the highest compressive strength The maximum force that can be tolerated for this scaffold in the pressure test is approximately 5 73 kN Then, by examining the results of the pressure test and the simulated model for the scaffold with square geometry, it was observed that the results of the experimental test and the simulated model for this scaffold are in good agreement
کلیدواژهها
نویسندگان
Abolfazl Foorginejad
Assistant Professor, Department of Mechanical Engineering, Birjand University of Technology
Vahid Abdollahi
MSc, Department of Mechanical Engineering, Birjand University of Technology
Sayyed Mohammad Emam
Associate Professor, Department of Mechanical Engineering, Ardakan University, P O Box ۱۸۴
Hosein Afshari
PhD Student, Department of Mechanical Engineering, University of Birjand
شیوه ارجاع
Foorginejad, Abolfazl and Abdollahi, Vahid and Emam, Sayyed Mohammad and Afshari, Hosein,1403,Study of Mechanical Properties and Porosity of Bio-scaffolds in Different Geometries,The10th International and 21th National Conference on Manufacturing Engineering,Tehran
ارائهشده در
مجموعه مقالات بیست و یکمین همایش ملی و دهمین کنفرانس بین المللی مهندسی ساخت و تولید ایران6 اسفند 1403 · تهران