چکیده مقاله
Microstructure, defects and hardness of 316L stainless steel fabricated by Direct Metal Deposition DMD method were investigated in this study 316Ll powder was depositedon a substrate of the same composition under the optimum operation parameters in a single pass mode Microstructural investigations were conducted along the builddirection as well as transverse to the build direction Boundaries of the melt pools and the final microstructure were studied by optical microscopy and dimensional measurements were conducted by ImageJ software Microstructural defects and distribution of the alloying elements were studied using scanning electron microscopy SEM and energydispersive X ray spectroscopy EDS analysis Different phases formed in the samples were identified by X ray diffraction analysis Hardness measurements were also conducted on the build direction of the sample Results indicated the formation of a dendritic cellular structure with an average arm diameter of 3 5 micrometers formed at a cooling rate of about 13000 K/s SEM and EDS analyses revealed formation of a small fraction of delta phase in the microstructure
کلیدواژهها
نویسندگان
شیوه ارجاع
Goli, Majid and Niroumand, Behzad and Toroghinejad, Mohammad Raza and Mosallanejad, Mohammad Hossein and Saboori, Abdollah,1399,Microstructural characterization of 316L stainless steel fabricated by direct metal deposition method,3rd International Conference on Welding and Non-Destructive Testing of Iran, 21st National Conference on Welding and Inspection and 10th National Conference on Non-Destructive Testing,Isfahan
ارائهشده در
مجموعه مقالات سومین کنفرانس بین المللی جوشکاری و آزمایش های غیرمخرب ایران، بیست و یکمین کنفرانس ملی جوش و بازرسی و دهمین کنفرانس ملی آزمایش های غیرمخرب13 اسفند 1399 · اصفهان