چکیده مقاله
Non heat treatable 5000 series aluminum alloys such as 5083 have been attracted the most attention for use in the marine industries In this research, the effect of gas metal arc welding process parameters on the angular distortion of 5083 aluminum alloy joint using ER5183 filler metal was investigated Accordingly, the wire feed speed, voltage, welding speed, and gas flow rate as the important parameters of the welding process changed at three levels Experiment design based on Taguchi method with orthogonal array L9 34 was performed and the results are analyzed using signal to noise ratio The analysis of the angular distortion test results showed that the wire feed speed, welding speed, voltage, and gas flow rate had the highest effect on the angular distortion, respectively The optimal values of 7 m min 1, 24 V, 0 9 m min 1, and 17 l min 1 were obtained for the wire feed speed, welding speed, voltage, and gas flow rate respectively The analysis of variance ANOVA of the DOE method was conducted and was observed that wire feed speed was the most significant GMAW process parameter due to its highest percentage contribution 56 83% among the process parameters
کلیدواژهها
نویسندگان
Mostafa Amra
Ph D , Padideh sanat ouj company, Iran
Mahmood Gordan
M Sc , Imen welding and cutting company
شیوه ارجاع
Amra, Mostafa and Gordan, Mahmood,1400,Optimization of GMAW process parameters on the 5083 aluminum alloy using Taguchi method in order to minimize the welding-induced distortion,4th International Conference on Welding and Non Destructive Testing & 22nd National Conference on Welding & Inspection & 11th National Conference on NDT,Isfahan
ارائهشده در
مجموعه مقالات چهارمین کنفرانس بین المللی جوشکاری و آزمایش های غیرمخرب و بیست و دومین کنفرانس ملی جوش و بازرسی و یازدهمین کنفرانس ملی آزمایش های غیرمخرب18 اسفند 1400 · اصفهان