چکیده مقاله
In this research, friction stir welding of aluminum 1050 to copper with variable speedwas investigated For friction stir welding, rotational speeds of 900 and 1200 rpm andtravers speeds of 36, 63 and 125 mm/min were used In order to check the phases andmicrostructure, scanning electron microscope analysis, X ray spectrometry and hardnesstesting were used The disturbance zone included Al2Cu3, Al4Cu9, AlCu4, Al2Cu andAlCu phases The results showed that the formation of intermetallic phases and severeplastic deformation in the welding area caused an increase in hardness The highest valueofhardness in the stirred area was 97 8 Vickers and at a rotation speed of900 rpm and anadvance speed of36 mm/min
کلیدواژهها
نویسندگان
M Ahmadi
Department of Mechanical Engineering, Kermanshah Branch, Islamic Azad University, Kermanshah
H. Reza Ahmadi
Assistant Professor of Materials Engineering, Saveh Branch, Islamic Azad University, Saveh
M.R Khanzadeh
Associate Professor, Technical and Engineering Faculty, Mobarakeh Branch, Islamic Azad University,Mobarakeh, Isfahan
H Bakhtiari
PhD students, Materials and Energy Research Center, Ceramics Research Institute, Karaj
شیوه ارجاع
Ahmadi, M and Ahmadi, H. Reza and Khanzadeh, M.R and Bakhtiari, H,1401,Evaluation of the effect of the variables of the friction stir welding of1050 Al and copper on the properties of the joint,5th International Conference on Welding and Non Destructive Testing & 23rd National Conference on Welding & Inspection & 12th National Conference on NDT,Isfahan
ارائهشده در
مجموعه مقالات پنجمین کنفرانس بین المللی جوشکاری و آزمایش های غیرمخرب،بیست و سومین کنفرانس ملی جوش و بازرسی و دوازدهمین کنفرانس ملی آزمایش های غیرمخرب و اولین کنفرانس ملی ساخت افزایشی10 اسفند 1401 · اصفهان