چکیده مقاله
This article demonstrates experimental investigations of the influence of cutting parameters on wire electrode wear in WEDM It is found experimentally that the increasing peak power and open circuit voltage increased the wire wear whereas the increasing wire speed decreases it Also Morphological studies have been conducted by studying the lateral and cross sectional surfaces of worn wire The wire specimens were suitably mounted on bakelite moulds Wherever required before their examination under the microscope
کلیدواژهها
نویسندگان
A.A Lotfi Neyestanak
MSc Graduate of Iran University Science and Technology
G.H Dehghan
Assistant Prof of Atomic Energy Organization of Iran
C Aghanajafi
Associate Prof of Mechanical Eng Dep of Khajeh Nasireddine Toosi University of Tech
P Pouladzadeh
MSc Student, young Researchers Club, Islamic Azad University, Branch of Qazvin
شیوه ارجاع
Lotfi Neyestanak, A.A and Dehghan, G.H and Aghanajafi, C and Pouladzadeh, P,1386,Morphological Studies and Quantities Evaluation on Wire Wear in Wire Electrical Discharge Machining,02nd Tehran International Congress on Manufacturing Engineering (TICME2007),Tehran
ارائهشده در
مجموعه مقالات دومین کنفرانس بین المللی و هشتمین کنفرانس ملی مهندسی ساخت و تولید10 اسفند 1386 · تهران