چکیده مقاله
It is practically impossible to manufacture a component exactly with the required dimensions Therefore for each part dimension, a tolerance limit is prescribed Also for all assemblies, a limit of variation is prescribed for a specified parameter of the assembly which is referred to as the assembly specification, and it could be the position of a point If the assembly specification has limits of variation in two or more directions, the correlation between these variations also impresses the limit of variation To determine the bivariate distribution of the assembly specification, in terms of part tolerances, the Direct Linearization Method DLM is used In this paper, the Coupler Point C P position of a crank slider mechanism during one cycle of motion is considered as the assembly specification The DLM results are validated with Monte Carlo simulation method and the percent contribution of each manufacturing variable in assembly specification is determined by multiple regression method This paper proposes that by tightening the tolerances of those manufacturing variables that have the highest contribution in the maximun error of mechanism, the amount of maximum error of mechanism could be decreased significantly
کلیدواژهها
نویسندگان
B Moetakef-Imani
Assistant ProfessorDepartment of Mechanical Engineering, Faculty of Engineering, Ferdowsi University of Mashhad, Iran
M Pour
M Sc Student Department of Mechanical Engineering, Faculty of Engineering, Ferdowsi University of Mashhad, Iran
شیوه ارجاع
Moetakef-Imani, B and Pour, M,1386,Position Error Reduction of Kinematic Mechanisms Using Tolerance Analysis and Cost Function,02nd Tehran International Congress on Manufacturing Engineering (TICME2007),Tehran
ارائهشده در
مجموعه مقالات دومین کنفرانس بین المللی و هشتمین کنفرانس ملی مهندسی ساخت و تولید10 اسفند 1386 · تهران