Fixture Locators Error Compensation by Modifying NC Codes in Three Axis Machining

چکیده مقاله

Fixture locators’ height error cause incorrect positioning of the workpiece in the fixture and inaccuracy in machined surfaces This paper presents a new method for compensating the fixture locators’ height error effect on workpiece machined surfaces In this method, the planes of workpiece Actual Coordinate System ACS are mathematically modelled in the workpiece Theoretical Coordinate System TCS Using the model, required Homogenous Transformation Matrix HTM for coinciding ACS with TCS and modifying machining toolpath for compensating the errors is generated The presented model is used to develop a postprocessing fixture Locator Error Compensation LEC module, which can modify NC machining codes to eliminate the effect of fixture locators’ height error on the workpiece machined surfaces For verifying the method, machining simulations using NX and VERICUT software have been performed The results show that the method eliminates the effect of fixture locators’ height error on the workpiece machined surfaces considerably

کلیدواژه‌ها

نویسندگان

M. Fallah

PhD Student, Mechanical Engineering Department, Amirkabir University of Technology, Tehran, Iran

B. Arezoo

Faculty, Mechanical Engineering Department, Amirkabir University of Technology, Tehran, Iran

Fallah, M. and Arezoo, B.,1390,Fixture Locators Error Compensation by Modifying NC Codes in Three Axis Machining,12th Iranian Conference on Manufacturing Engineering (ICME 2010),Tehran

ارائه‌شده در

مجموعه مقالات دوازدهمین کنفرانس ملی مهندسی ساخت و تولید ایران6 دی 1390 · تهران