چکیده مقاله
Al-Al3Ni composites due to their high strength, creep resistance, fatigue resistance, good ductility, adequate toughness, high corrosion resistance and hardness have gained considerable attention in recent years. In the present investigation, for the first time, powder metallurgy (PM) method was used to in-situ produce Al-Al3Ni composites. Commercially pure aluminum powders (63-125 μm) and the same sized pure nickel powders used as starting materials. The Al and Ni powders were initially soaked in NaOH and acetone respectively to remove their surface impurities. The Al/Ni powder mixtures with different Ni contents subjected to cold pressing and sintering at different temperatures for various times. Samples of Al powders without Ni addition were also prepared using identical procedures as for Al/Ni composites to serve as the reference samples. The results of XRD, optical microscopy and SEM studies as well as Brinell hardness measurements performed on the sintered compacts revealed that even after 75 minutes sintering of an Al/Ni compact at 640 ˚C, the unreacted Ni particles could be detected in the sample. The increased sintering temperature to 655˚C resulted in more effective interaction between Al and Ni during sintering at 15 minutes. However, sintering at this temperature for longer periods of time resulted in partial melting and deformation of the samples. Therefore, Ni powders subjected to high-energy ball milling to increase their activity. The XRD results confirmed that sintering at 655˚C of the Al/Ni powder compact containing 15wt.% of ball-milled Ni resulted in complete reaction and Al-Al3Ni eutectic formed without any unreacted Ni. The porosity level of the samples increased with increasing percentage of Al3Ni phase in the matrix. Brinell hardness values of all the composite samples were higher than that of their reference counterpart. The Al-20wt.% Ni sample prepared by milled Ni exhibited the maximum hardness value being almost three times of that of the reference sample. However, the increased content of milled Ni to 25wt.% resulted in some unreacted Ni particles in the matrix as was confirmed by XRD studies.
کلیدواژهها
نویسندگان
Farshad Akhlaghi
School of Metallurgy and Materials Engineering, College of Engineering, University of Tehran P. O. Box ۱۱۱۵۵-۴۵۶۳, Tehran, Iran
Fatemeh Abedini
School of Metallurgy and Materials Engineering, College of Engineering, University of Tehran P. O. Box ۱۱۱۵۵-۴۵۶۳, Tehran, Iran
شیوه ارجاع
Akhlaghi, Farshad and Abedini, Fatemeh,1401,Characterization of Al-Al3Ni Composites Synthesized In-situ via Powder Metallurgy Method,Twelfth International Conference on Innovation and Research in Engineering Sciences
ارائهشده در
مجموعه مقالات دوازدهمین کنفرانس بین المللی نوآوری و تحقیق در علوم مهندسی10 تیر 1401